Additional information
ICS Code | |
---|---|
ICS Name | |
Edition | |
Legal Status | |
Pages | |
Published Date | |
Replaced by | |
Replaces | |
Sector | |
Standard Development Stage | |
Standard Status | |
Technical Committee | |
Type of Standards |
P376.20
Water quality — Determination of chromium — Atomic absorption spectrometric methods
ICS Code | |
---|---|
ICS Name | |
Edition | |
Legal Status | |
Pages | |
Published Date | |
Replaced by | |
Replaces | |
Sector | |
Standard Development Stage | |
Standard Status | |
Technical Committee | |
Type of Standards |
This International Standard specifies two methods for the determination of chromium in water by atomic absorption spectrometry. The two methods are covered in separate clauses as follows: ¾ Clause 3: Determination of chromium by flame atomic absorption spectrometry; ¾ Clause 4: Determination of chromium by electrothermal atomization atomic absorption spectrometry. Clause 3 is applicable to the analysis of water and waste water when the concentration range is between 0,5 mg/l and 20 mg/l of chromium. When the concentration is below 0,5 mg/l, the determination can be carried out after carefully evaporating an acidified sample to small volume, taking care to avoid the formation of a precipitate.
NOTE The use of evaporation will increase the effect of interfering substances and therefore for concentrations below 0,1 mg/l
the method in clause 4 is given.
Clause 4 is applicable to the analysis of water and waste water when the concentration range is between 5 mg/l and
100 mg/l of chromium by injecting a sample volume of 20 ml. It is applicable to the determination of higher
concentrations by using a smaller sample volume.